What size whole house generator do I need? For most homes in Parrish, FL, the honest answer is a number from a load calculation, not a guess from square footage. Standby units for houses are typically sold from about 10 to 26 kilowatts, with larger liquid-cooled models above that. Where your house lands depends on what you want running at the same time. The biggest factors are central air, an electric range, an electric water heater, a well pump and an EV charger. A home keeping only essential circuits often sits at the low end. A home that wants everything on, with load management, often sits near the top. A licensed electrician confirms it by adding up your real loads.
Signs your whole house generator size needs a real load calculation
You need a proper sizing visit as soon as one big electric load is on your must-run list. A kilowatt is 1,000 watts, and a generator’s rating is the most it can carry at one moment. Small things like lights, a refrigerator and the internet barely move that number. A handful of large loads decide it.
- You want central air to keep running, and in a Florida summer most people do.
- The house is all electric: range, water heater and dryer.
- A well pump or pool pump has to stay on.
- You charge an EV at home.
- The home has two air conditioning systems.
- Someone relies on powered medical equipment, or works from home.
- The only size you’ve been given came from square footage.
There’s one more wrinkle, and it’s the reason guesses go wrong. A motor needs a short burst of extra power to start, often a few times what it draws once it’s running. That is the difference between starting load and running load. The generator has to cover that burst on top of everything already on, so the air conditioner or the well pump often sets the size by itself. Working that out is the first step of our home generator installation service.
When you don’t need a unit that big, and what to do instead
Picture a couple in a gas-cooking home who only want the refrigerator, some lights, the internet and one air conditioner during an outage. They don’t need a machine sized for the whole panel. They need an essential-circuits setup: a smaller standby unit wired to the circuits they picked, with everything else left off until the grid comes back.
You can skip the largest sizes if any of these describe you:
- Your must-run list is short and has no more than one large motor on it.
- The range, water heater and dryer already run on gas.
- You’re fine with big loads taking turns instead of running together.
- Outages on your street are short and rare.
If the last line is you, a permanent system may not earn its place at all, and our guide on whether a whole house generator is worth it walks through that test. If the list is only a fridge and a few lights, read how a standby unit compares with a portable one before you spend on either. And if you want the whole home covered without the largest unit, ask about load management. It holds a big load back until there’s room for it.

What a wrong size or a long wait costs you
Most people assume bigger is the safe choice. In practice a mistake in either direction costs you. A unit that is too small overloads when the air conditioner kicks on with the range and the water heater already running. It will shut down or drop loads, usually on the hottest night of the outage. A unit far too large costs more up front and burns more fuel every hour it runs.
Size also reaches past the generator itself. A larger unit uses more fuel, so the gas meter, the gas line or the propane tank has to keep up with it. Our natural gas and propane comparison explains that side. We don’t publish prices, because the number moves with the unit size, the fuel run, the type of transfer switch, any panel work, and the permit and inspection. A free estimate puts those in writing for your house.
Waiting has its own cost. Hurricane season runs from June 1 to November 30, and the permit office, the inspector and the fuel supplier each keep their own schedule. None of them speed up because a storm is in the forecast. The other surprise is the panel. A full or worn-out panel can limit what a generator may connect to, and it’s better to learn that before a unit is ordered. For homeowners south of the river, our page on panel replacement in Bradenton shows what that job involves.
Not sure what shape your panel and wiring are in? An electrical safety inspection answers that before you settle on a size.
The checklist: what size whole house generator do I need?
Nine questions, one point for every yes. Answer for the way you want the house to run during an outage, not the way it runs today.
- Do you want central air to run during an outage?
- Does the home have more than one air conditioning system?
- Do you cook on an electric range or oven?
- Is the water heater electric?
- Is the clothes dryer electric?
- Does a well pump or pool pump need to keep running?
- Do you charge an EV at home?
- Does anyone rely on powered medical equipment, or work from home?
- Do you want every circuit live, with no loads taking turns?
Now add it up. The table shows where each score usually points. Treat the sizes as typical classes, not a quote and not a final answer.
| Your score | Likely setup | Typical size class |
|---|---|---|
| 0 to 2 | Essential circuits | Often 10 to 14 kW |
| 3 to 5 | Whole home, managed loads | Often 18 to 26 kW |
| 6 to 9 | Whole home, heavy electric use | Often 26 kW or larger |
Here is why the score can’t be the last word. Take a single-story Parrish home with one central air system, a gas range and a gas water heater. Most of its heavy loads are already off the electric side, so a mid-size unit can often carry the whole house. Put the same floor plan on all-electric appliances, add a well pump and an EV charger, and the answer changes. That house needs a larger unit, or load management that makes the big loads take turns. Same square footage, different generator. Only a load calculation on your own equipment settles it.

Your first thirty days after you decide
The first month is mostly planning and paperwork, and that’s normal. Here is the usual order.
- Site visit. An electrician looks at the panel, the meter, the air conditioner nameplates and the spot where the unit could sit.
- Load calculation. Your must-run list becomes a number, with starting loads included.
- Written recommendation. You get a unit size, a fuel type, a transfer switch choice and any panel work, on paper.
- Permit. The permit application goes in, since a standby generator is permitted electrical work.
- Fuel plan. The gas utility or the propane supplier confirms the supply can feed the unit.
- Install and test. The unit is set, connected and run under load, and then the inspection is scheduled.
How much of that fits inside thirty days depends on the permit office, the fuel supplier and equipment availability, so nobody can promise you a date before seeing the house. What you can control is the start. Have your list ready and the visit goes faster. Don’t open the panel to gather information for it. A photo of the closed panel and the meter is plenty.
How Bluefin Power Solutions sizes a generator for your home
Bluefin Power Solutions is a Florida Certified Electrical Contractor, License EC13013906, based in Parrish, FL. We’re licensed and insured under that number, we hold a 5.0 rating on Google, and we serve Manatee, Sarasota and the south Tampa Bay area.
Sizing starts with your list, not a brochure. We ask what has to stay on, read the nameplates on the air conditioner and the other large equipment, and check the panel and the meter. Then we run the load calculation and show you the result. If a smaller unit with load management will do the job, we’ll say so. If the panel or the fuel supply limits your options, you hear that before anything is ordered.
That’s also a fair test for any installer you talk to. Ask for the load calculation in writing, the licence number, proof of insurance and who pulls the permit. Be careful with a size quoted over the phone from square footage alone. Financing available through Synchrony. The full process, from the first visit to the inspection, is on our whole house generator installation page.
Wondering whether we cover your street? The list of the areas we serve names every town we work in.
Whole house generator sizing FAQ
How many kW do I need to run my whole house?
It depends on your loads, not your square footage. Standby units for homes are typically sold from about 10 to 26 kilowatts, and a load calculation shows where your house falls.
What size generator do I need for a 2,000 square foot house?
Square footage alone can’t answer that. Two 2,000 square foot homes can need very different units, depending on the air conditioning, the electric appliances and whether there’s a well pump.
Can a whole house generator run central air conditioning?
Yes, when it’s sized for the air conditioner’s starting load. Starting takes more power than running, so the air conditioner is often the load that sets the size.
Is it bad to oversize a whole house generator?
A unit far larger than you need costs more to buy and burns more fuel. Some headroom is sensible, and the load calculation shows how much.
What is load management on a generator?
Load management holds back big loads, such as a second air conditioner or an EV charger, until the generator has room for them. It lets a smaller unit cover a whole home, with the trade-off that not everything runs at the same moment.
Do I need a bigger gas line or propane tank for a larger generator?
You might. A larger unit uses more fuel, so the gas meter, the line or the tank has to be checked against it by the gas utility or your propane supplier.
Can I size a whole house generator myself?
You can list what you want to run, and that list helps. The final size should come from a licensed electrician’s load calculation, because the unit ties into your panel, the permit and the inspection.
Do I need a permit to install a whole house generator in Florida?
Yes. A standby generator is permitted electrical work with an inspection, and we handle both.
Get your generator sized before you buy
Bring your checklist score and your must-run list, and we’ll turn them into a load calculation for your home. Get a Free Estimate from Bluefin Power Solutions. We’re open Monday to Friday, 8 AM to 6 PM, and you’ll get the recommended size in writing.